2000 Suburban remote

[kewltime]

I have a gm/uta 15732803 remote and the book doesn't tell how to program it. does anyone know how?:flash:

[cobra1]

not sure if this will work on your model, but the # on your remote matches mine, and this is the procedure i use on mine.



With the driver door closed, hold down the power unlock button on the door panel.
Turn the ignition switch to the ON position.
Turn the ignition switch to the OFF position.
Turn the ignition switch to the ON position.
Turn the ignition switch to the OFF position.
Release the power unlock button on the door panel. The remote control door lock receiver will respond in the following manner in order to indicate that the receiver is in the programming mode:
Locking the doors
Unlocking the doors

Important
All extra transmitters must be programmed at this time. When a new transmitter is programmed, it will deactivate the old transmitters.


Hold down the lock and unlock buttons on the transmitter until the remote control door lock receiver will respond in the following manner:
Locking the doors.
Unlocking the doors.
Repeat step 7 for each additional transmitter.
Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

[fernando2000]

Cool, it worked Great!!