 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Quality Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
05-07-2011, 06:12 PM
|
#1 | |
|
AF Enthusiast
Join Date: Aug 2004
Location: Sharon, Pennsylvania
Posts: 2,746
Thanks: 0
Thanked 1 Time in 1 Post
|
97 Neon DOHC Engien problem
working on a 97 Dodge Neon DOHC, diff pin broke and shattered the tranny case, while replacing the tranny we rebuilt the engine. well the engine had a slight knock which got worse after a couple weeks. Tore the pan off and seen it had a spun bearing, replaced the crank, rods and pistons and all the bearings, seals and gaskets again. made sure all the clearances were within spec and everything was good. got everything back together and installed.
Started the engine, before installing the radiator and hoses and such, still had a knock ,after about a minute of running oil started pouring out of the back of the water pump/radiator hose connection. When we removed the pan we noticed coolant in the oil. Any ideas what the problem could be besides head gasket? I'm thinking a crack in the block somewhere, from the impact of the tranny shattering.
__________________
R.I.P. - 94 Jeep Grand Cherokee Limited 5.2L V8 Quadra-Trac, 3" Budget Boost, K&N FIPK Gen II (Cold Air Intake), FlowMaster American Thunder (Exhaust). W.T.T.F. - 1998 Jeep Grand Cherokee 5.9 Limited - Deep Slate Pearl - K&N FIPK GEN II (COLD AIR INTAKE), Altezza Tails and Crystal Clear Front end light with HID Kit and NP242 Swap. 
|
|
|
|
|
05-08-2011, 03:42 PM
|
#2 | |
|
Tuning Neons since '97
 Join Date: May 2005
Location: Houston, Texas
Posts: 3,104
Thanks: 0
Thanked 15 Times in 15 Posts
|
Re: 97 Neon DOHC Engien problem
Cracked block or warped head.
__________________
2003 Dodge SRT-4 |
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
