More vids of that ill Evo VII with 800hp!

[Blitzen]

OK, so I rounded up the figure by about 20hp

Most of you who replied in my previos thread about this car would be dying to see this car again.

Check out these sites:

www.lancer-evo.net/video/download/video-178.zip

Also :

http://www.adyscars.pwp.blueyonder.co.uk/videos.htm

Aren't I just an asset to AF

[Blitzen]

Oh come on 28 views and still no reply? Its an 800hp Evo vii!

[JDM_USA]

*yawn* :o

[Blitzen]

Its an 800HP Evo and your yawning? Once you see this car, youd be in shock-and-awe.

[2of9]

nice Evo 7

[Blitzen]

[flylwsi]

maybe we're too busy dl'ing and drooling...

[Blitzen]

maybe we're too busy dl'ing and drooling...

Fully understandable.

[Blitzen]

Oh, and the spec list:

Owner:
Simon Thornton-Norris
Phone:
+44 1249 712024
E-Mail:
[email protected]
Updated:
24.02.2003
Engin Mods:
Engine - Mitsubishi 4G63 4 Cylinder 16 Valve

Engine Dyno - 684 Hp & 578Lbft (2.1 Bar)
771Hp & 643LbFt (2.5 Bar)

Interpro Rolling Road - No Hp Reading, 608LbFt (2.1 Bar) (Could not stop all four wheels spinning after 5000 Rpm)

G-Force Rolling Road - 715Hp & 602LbFt (2.1Bar)

Target Weight 1200-1250Kg
0-60Mph - 2.79 So Far (Road Tyres)
0-100Mph - 5.99 So Far (Road Tyres)
1/4 Mile Target - Sub 10.5 Secs
Top Speed Target - 215 Mph
ND Boot Mounted Aluminium Fuel Tank
ND Boot Mounted Water Injection Tank
Twin Bosch 044 Fuel Pumps
Twin Dash 8 Fuel Regulators
Twin Post Filters
Twin Pre Filters
Dash 8 Full Fuel Lines
Modified HKS Fuel Rail
1000cc Injectors (Too Small for 2.5 Bar Boost!!!)
JUN Racing Inlet Manifold (80mm Throttle)
ERL Water Injection System
Motec Engine Management With Launch Control
4 Bar TTE Map Sensor
HKS Hiper Muffler Exhaust
HKS De-Cat Pipe
HKS Cam Pulleys
ND Valve Spring Kit
JUN Camshafts
JUN Titanium Retainers
ND Solid Lifters
ND Racing Cylinder Head
HKS Metal Head Gasket
ARP Head Stud Kit
Tomei Engine Stud Kit
ND GT Spec Forged Piston Kit
JUN Stroker Kit (Not Pistons)
ND Modified Sump
HKS GT3240 Special Full Turbine Kit
ND Oil Cooler Kit
Greddy Intercooler Kit
ND 3" Intercooler Pipes
Ralliart Racing Thermostat
Ralliart Racing Radiator Cap
Samco Water Hoses
Carbon Air Box With Greddy Air Filter
Ralliart Earthing System
Ralliart HT Leads
NGK Racing Spark Plugs
Cusco Catch Tank
Plus Lots Lots More!


Interior Mods:
Carbon Bonnet
Carbon Splitter
Carbon Spoiler
Carbon Grille
Stack Dash 8130P
Motec PLM Display
ERL Water Injection Flow Gauge
Twin 4 Point Harness's
Clear Rear Lights

Chassi Mods:
ND Full Vehicle Graphics
Proflex Suspension
Cusco Three Point Front Strut Brace
Cusco Carbon Rear Strut Brace
Cusco Pillowball Top Mounts
Cusco Front Antiroll Bar
Cusco Rear Antiroll Bar
Ralliart Master Cylinder Support
Cusco Suspension Cradle
Uprated Suspension Bushes
Uprated Rear Diff Bushes
ND Gearbox
ND Twin Plate Push Clutch Kit
76 Racing Lubricants

Brake Mods:
AP Racing Front Brakes 6 Pot 330mm
Brembo Rear Brakes With Greenstuff Pads
R600+ Racing Brake & Clutch Fluid
Mintex F4R Carbon Front Pads

Wheel Mods:
8 X 18" Alloy Wheels
Toyo Proxes 235/40/18

8 X 18" Compomotive Alloy Wheels
Tarmac Slicks

Sound Mods:

Buildtime:
Virtually Finished
Cost:
£70,000 Total So Far
Awards:

Thanks:

The performance figures have been proven.

Nothing short of amazing