|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
03-22-2003, 06:42 PM
|
||||
|
||||
Nice Looking exhaust..
.. I finally found the right size tubing to make a Very nice Jdm looking exhaust, Here are the sizes, 5/32 and 3/16, I bought some brass ones couldnt find aluminum. Here are the pics, All you do is slide the 5/32 one into the 3/16 one and cut to desired lenght. Here are some pics:
  I think they are the perfect size for any car, they dont look like fart cans. 
|
|
#2
03-22-2003, 06:43 PM
|
||||
|
||||
|
looks pretty good from what i can see
|
|
#4
03-22-2003, 06:53 PM
|
|||
|
|||
|
Bought the same brass tubes! To make the tip more skinnier, I scraped the inside with a knife until it got thin. It cuts brass easy. Here are pics:
  
__________________
 05' Civic Si - Tokico D-Specs/Progress Springs/Progress Rear Sway/CorSport Endlinks/Ingalls Torque Dampner/Energy Suspension Motor Mounts/Falken Ziex/HFP Spoiler/RSX Rims
|
|
#6
03-22-2003, 06:54 PM
|
||||
|
||||
|
Hey ryan, what did you use to cut it? I had a hard time cutting it.
|
|
#7
03-22-2003, 06:56 PM
|
||||
|
||||
|
Quote:
|
|
#8
03-22-2003, 07:01 PM
|
|||
|
|||
|
Quote:
__________________
05' Civic Si - Tokico D-Specs/Progress Springs/Progress Rear Sway/CorSport Endlinks/Ingalls Torque Dampner/Energy Suspension Motor Mounts/Falken Ziex/HFP Spoiler/RSX Rims
|
|
#9
03-22-2003, 07:21 PM
|
||||
|
||||
|
Quote:
|
|
#10
03-23-2003, 07:27 AM
|
||||
|
||||
|
both exhausts look good,
|
| |||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
