|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-18-2002, 04:58 PM
|
|||
|
|||
|
my car is on jack stands.....help
i have a 96 LS integra... i just installed my dc header and i pulled the o2 sensor wires from the little gray box where they are plugged into.... and now i can't figure out which wire goes where.... there are 4 wires, 1 green, 1 white and 2 black.... i tried to line them up on the other side of the gray box, but they are different colours... so i'm not sure which wire goes where.... i need some help asap because my car is sitting on jack stands right now
__________________
---1996 Black Acura Integra---- Integra Type R Front Lip Spoiler Autometer 5" SportComp Silver Tach w/Lite Autometer Full dual pod pillar with A/F and Water Temp. Gauges 5Zigen Fireball Exhaust AEM Cold Air Intake DC Sports 4-2-1 Header Eibach Sportlines Tokico Blue Shocks DC Sports Short Shifter Strut Tower Bar Titinium ITR Knob 98+ OEM taillights Momo Pedals Sony 700 Series CD/MD shipping.... WW RS sides and rear 
|
|
#2
04-18-2002, 05:04 PM
|
||||
|
||||
|
the green wire is the ground, the white is the hot, and the black ones are the signal. just find out which one is which from the o2 sensor and hook it back up.
__________________
1994 civic ex - b16a sir2 w/lsd too much to list http://www.cardomain.com/memberpage/423478
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
