custom piping calgary

[RickDaTuner]

anyone want to give me a place where they do custom piping for an exhaust and roughly how much it would be to do a 2.50 inch pipe set up

[Superesc]

kinda wondering the same thing, but more of if there's a bolt on Mid pipe for sale around town... does a ITR's midpipe fit a GS????

Rick: Just wondering if you go with 2.5", do you need an aftermarket cat converter??

-Cal

[buh_buh]

I had custom piping on my '93 Prelude, I got it done at a Minute Muffler in Forest Lawn. It was a place that was recommended to me by a couple people, and they did a pretty good job. It cost me about $200. Hope that helps.

[RickDaTuner]

Originally posted by Superesc
kinda wondering the same thing, but more of if there's a bolt on Mid pipe for sale around town... does a ITR's midpipe fit a GS????

Rick: Just wondering if you go with 2.5", do you need an aftermarket cat converter??

-Cal

well whgat I want is to remove my cat completely I wonder if someone will do it here in calgary or if its still illegal hmmm i'll check around today whem I go down to calgary

[RickDaTuner]

Originally posted by buh_buh
I had custom piping on my '93 Prelude, I got it done at a Minute Muffler in Forest Lawn. It was a place that was recommended to me by a couple people, and they did a pretty good job. It cost me about $200. Hope that helps.

gee $200 that sounds kinda steep i've heard of them being dome for like 120 bucks and a good job to

[Superesc]

Have anyone tried Carline Muffler? RPM have their cards on their counter. Might want to get a quote from them.

Bay 5, 727 - 33rd St. NE
Phone: 403- 273-4506

[Beyond Imagination]

Check out McCall Lake Muffler ... it's on 32nd Ave NE
They do all my muffler work ...

[90civicrider]

had mine done at Calgary Muffler by chinook. really good place. pretty cheap too! i payed 425$ for my cat-back 2 14" with a muffler and tip!
so just piping would probably be around 200-250?? i'm not to sure tho

[Dru-Si]

I've never been a big fan of custom exhausts, for 2 reasons.

1. I don't think any shops in Calgary can do mandrel bends, cuz most likely you'll get crush bends. So what's the point? Crush bends = loss of power.

2. You get what you pay for. Call me crazy but I went with a Greddy for my car. Sure it costs more, but I know the quality is top-notch, and it's mandrel bent.