mods and money

[scottb2004]

i have two questions this time. how much power and what can i get my 1/4 mi. time down to w/ aftermarket: boost controller, uppipe, downpipe, cat-back exhaust, blow off valve, fuel pump, plugs....and stock turbo, engine, and tranny?

secondly, what would i have to do to get the WRX into high 12 sec. 1/4 mi. times?

[scottb2004]

also....what is better getting a boost controller or a upgraded chip/ecu/utec/unichip...

[ragnarok]

I have my car down to 13 flat with less than that slightly. I have a catlesss up and downpipe, no exhaust on when i race besides the before mentioned, 110 octane, boost set at 15.5 lbs, AEM cai, 9 lbs flywheel, stage 2 racing clutch, fartboy short throw shifter, ZR tires, GFB BOV, Greddy Profec B boost controller, and a MRT Boost cut defender. Also to the latest question, its best to have a UTEC chip and boost controller. The utec will allow you to set boost, fuel air ratios and other small tuning things. The boost controller will allow you to boost past your setting on the utec. Dont wanna be retuning the car for street and race all the time.

[2turboimports]

you can hit high 12's w/out changing out the turbo. I think the MAJOR factor will be an upgraded chip though.

[ragnarok]

My method is kind of crued and not too reliable. Getting a stand alone ECU and new fuel system to help with higher boost will put you in the 12's pretty good but you will want a new turbo so you dont over stress the stock one.

[scottb2004]

thanks a lot guys....this has really helped me figure out what i need to do to get my WRX as fast i was hoping i could get it....i was more concerned with what parts i was going to have to get and what they were going to cost. i am 100% going to do lots of mods i just didn't know exactly where to start. thanks a lot guys for helping me.

[ragnarok]

This should help you out.
www.gruppe-s.com
www.jscspeed.com