|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#2
08-08-2003, 11:21 AM
|
|||
|
|||
|
Not sure, but here's the diagram from my repair manual:
__________________
1995 Honda Accord LX...all stocked out! http://www.cardomain.com/member_page...page_id=356187 
|
|
#3
08-08-2003, 09:18 PM
|
||||
|
||||
|
That would be correct. Dont tighten the throttle cable.
Adjust idle w/ engine warm & no electronics ON
|
|
#4
09-02-2003, 07:07 PM
|
|||
|
|||
|
Need Idle Adjustment Please
I recently aquired a 1988 Honda Accord. The mechanic that I talked to told me to adjust the idle by adjusting the throtle cable. Now this guy is pretty smart, so I listened to him. Turns out that the cable adjusting nuts were very loose (1/4" loose per side). So I adjusted it using that.
Went to get my emmissions tested today, and had to leave because when I got there, the car MYSTERIOUSLY started idling at 2000 RPM. Before that, it was 3000 RPM. I came home and re re readjusted the idle. Now it is doing pretty good, but it tends to die when I switch the A/C on and off. NOW I look under the breatheronly to find that there is yet another mystery adjustment screw on the left side of the carb. I am at a loss here. Can anybody shed some light on what all of these adjustment screws are for? (View described is facing engine from front of car) Thanks, Llackej1971
|
|
#5
09-02-2003, 11:43 PM
|
||||
|
||||
 you dont adjust the idle by turning the throttle cable. Adjusting the throttle cable is for removing any free-play. Adjust the idle with Idle Adjustment Screw - probably the one your talkin about.
|
| ||||||||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
