|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
Repsol Honda RS250RW
It seems that Hasegawa is coming up with another Honda RS250RW and this time it's 2007 Repsol Honda RS250RW rode by Shuhei Aoyama. I know that I'm currently stuck with the Scot Team as I'm having problem currently.
![]() After experiencing the Scot Team, I'm not sure if Hasegawa will improve from there. I'm being hopeful that the Repsol version will be better this time. Hopefully. What are your opinions? Adrian |
|
#2
|
||||
|
||||
|
Re: Repsol Honda RS250RW
Well, it's more than likely to be the same basic kit that would, hopefully, reflect the changes between the bikes and have different decals included.
What's wrong with the 2009 kit?
__________________
![]() Would love to resume my duties as AF's own official thread bastardizer!!! ![]() 1:29:53.435 || 207.316 || 310.596 |
|
#3
|
|||
|
|||
|
Re: Repsol Honda RS250RW
The problem I faced that time was the screws didn't fit right. Otherwise, it'll be a good kit. I hope to see some improvement on the Repsol version.
Adrian |
|
#4
|
||||
|
||||
|
Re: Repsol Honda RS250RW
It's likely to be the same kit - 250cc bikes didn't change much over the years and it's widely known Honda stopped developing their 250 bikes sometime in 2007 - which makes the Aoyama's 2009 championship all the more remarkable.
I've one on pre-order as I prefer the Repsol scheme - lots of flou colours!!
__________________
Paul On the bench; 2003 LV Rossi Honda RC211V |
|
#5
|
|||
|
|||
|
Re: Repsol Honda RS250RW
I just hope that they improve the screw sets as the length in the Scot team is a few mm short.
Adrian |
|
#6
|
||||
|
||||
|
Re: Repsol Honda RS250RW
I've not heard of that problem before - are you sure it's an issue with the kit?? Perhaps something did'nt go into place properly??
__________________
Paul On the bench; 2003 LV Rossi Honda RC211V |
|
#7
|
|||
|
|||
|
Re: Repsol Honda RS250RW
I've tried ways to get it screwed but I suspected that it was a mm or two short. But, I'll give another go for the Scot Team again.... *sigh*
Just hope for the best.... ![]() Adrian |
| ||||||||||||||||||||||||||||||||||||||
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|