|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
09-08-2002, 01:09 AM
|
|||
|
|||
|
oxygen sensor
is it possible to clean the tip and reuse?? i was looking on kragens site, and a new bosch o.e. sensor was over $200.
they had a universal one without connectors for under $100. if i was to get that one, what would i need to do to make it usable? how would i wire it? im assuming it would be a huge hassle since its so much cheaper. has anyone had experience with installing a new one?
__________________
|
|
#2
09-08-2002, 02:00 AM
|
||||
|
||||
|
Mine was easy to install. But was also a lot cheaper. Mine cost like 60 bucks, with the connector. I would think you would be able to get the one without a end and splice it onto the old plug.
__________________
 AF Bay Area Crew RIP Melt 2008 Mitsubishi Lancer Evolution GSR 2007 Toyota Prius   I <3 and miss my 4g 
|
|
#3
09-08-2002, 06:24 PM
|
|||
|
|||
|
yea thanks. i did a little more searching and i found that i can do exactly what you said. although i'd use just a single wire sensor, meaning that i wont be able to have it heated.
one more thing. i saw on ebay a couple ngk sensors, but none for my year. if i were to cut off the wires and splice just the single to the harness, would it work?? are all sensors threaded the same?
__________________
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
