|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-12-2003, 01:20 AM
|
|||
|
|||
|
intake barrel swap Question
I just finished bolting in a 91 crx 1.6 and was wondering if anyone can help me with the wiring for the pgm-fi intake barrel I found info on dx to zc wiring but not tottally sure if its the same and if anyone had some better info for me there has to be a easier way then what I have found, " any info will help"
|
|
#2
08-12-2003, 01:57 AM
|
||||
|
||||
|
What the hell is an intake barrel?
And the only difference between Si and ZC wiring is that on ZC it has 2 wires (C1 and C2 from the ECU) going to the Cylinder Position Sensor on the exhaust cam as opposed to C1 and C2 going to the CPS inside of the distributor of the Si. You will notice ZC has 5 wires on the distributor and Si has 7. The extra 2 are because of the CPS inside the distributor.
__________________
http://www.fourthgenhatch.com FOR SALE: Get this stuff out of my house! -Stock hood (red) $30 -Stock Rear Spoiler (red) $30 -Stock mirrors $30/both -Stock side front and rear side glass $30/piece
|
|
#3
08-12-2003, 02:34 PM
|
|||
|
|||
|
Maybe he's talking about the throttle body?
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
