|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
11-06-2007, 08:50 PM
|
|||
|
|||
How to get a torque converter off a van
I have a 96 chevy astrovan and I need some help in getting the torque converter off. There is no dust pan like normal. How do you get to the torque converter off??? Help, anybody!
|
|
#2
11-06-2007, 09:25 PM
|
||||
|
||||
|
Re: How to get a torque converter off a van
You have to remove the 3 torque converter bolts that hold it to the flexplate. To do that you have to rotate the engine until you see the bolt. Then support the engine and tranny with a jack, remove the driveshaft, unbolt the tranny and crossmember, slide it back, then the TC just slides out. Expect lots of fluid to come out... like several quarts.
__________________
Dragging people kicking and screaming into the enlightenment.
|
|
#3
11-06-2007, 09:32 PM
|
|||
|
|||
|
Re: How to get a torque converter off a van
I can't get to the bolts there is normally a dust cover that you remove but this van has casting all around the trans. There is no access to the bolts I can see.
|
|
#4
11-06-2007, 11:13 PM
|
|||
|
|||
|
Re: How to get a torque converter off a van
I believe you pull the starter and there's access through the hole
__________________
life begins at 10psi of boost Three turbo'd motorcycles and counting. 
|
|
#5
11-06-2007, 11:18 PM
|
|||
|
|||
|
Re: How to get a torque converter off a van
Thanks UncleBob, I will see if now I can fight this van again, now for the starter.
|
|
#6
11-07-2007, 05:39 PM
|
||||
|
||||
|
Re: How to get a torque converter off a van
Kinda puzzles me that a 96 has a full bellhousing on it. They had the 4L60E which should be the dust cover kind. But UncleBob is right.. .you pull the starter to get access to those bolts.
__________________
Dragging people kicking and screaming into the enlightenment.
|
|
#7
11-07-2007, 05:55 PM
|
|||
|
|||
|
Re: How to get a torque converter off a van
Thank you we are about to go out and take a look at it. I will be back on if that does not work.
|
|
#8
11-08-2007, 12:30 PM
|
|||
|
|||
|
Re: How to get a torque converter off a van
I probably should have been more specific, my data shows a diagram that suggests there is a removable cover, but the instructions mention pulling the starter to get to the bolts.
Unfortunately, this kind of conflict is common, and without being there and looking at it, I'm not sure which is which, but I assume if you say there's no removable cover, then there isn't 
__________________
life begins at 10psi of boost Three turbo'd motorcycles and counting.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
