|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Non Specific This is the forum to post and generalized racing questions. |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
||||
|
||||
|
10.94 @ 129.8
Well it's been forever in the coming.
It was pretty, but it happened ... Hyde went 10s. First off, a HUGE thanks to Josh @ Chico Race Works ... this run was for him. Thank you JOSH!!! I took the day off of work on Friday to trailer to Atco Raceway, one the bigger NHRA tracks in the region. It's a 2.5 hour driver, but Philadelphia traffic screwed me and it took over 3.5 hours to get ther *sigh* We rolled Hyde out of the trailer, got it tech'ed warmed up the engine and got in line. Atco was also doing the "put a cone in the groove so the street tire cars do not pull up the rubber in the groove." *sigh* So a stupid little pylon was forcing me out of the groove. I had a decent burnout, managed only a 1.9 in the 60', but made a whopping 103 mph in the 1/8 and went on to a blistering 11.3 @ 130 mph. I got right back in line, and not even 10 minutes later I got run #2. I made some adjustments to the boost controller and managed a much better burnout. Still out of the groove I nailed a 1.67 in the 60' for a 11.12 @ 128 mph. That was a new best for Hyde as last year I went 11.13 @ 125. I got out of the whole better, but the boost controller adjust obviously killed my mph. So, to go for the 10, I cranked the gain back up and then some ... fiddled with the ratio a little bit and got back in line. That's when I learned there was a separate line for slick and drag radial cars. If you are in that line, they move the cone and you get the groove. I was too far in my line though to switch and I just asked the guy in the burnout bow to move the cone which he did! ![]() Funny stuff: So I attempted a burnout and it failed misserable. I just hooked up and hte car inched forward pushing the front tires. I killed the burnout, and reinitiated the process for a second burnout ... no dice. The car just went forward. I think the clutch/flywheel was not holding enough power to smoke the tires in second gear, but it was grabbing enough that pathetically pushed the car forward ... such is life. At any rate, trying to do 2 burnouts was enoguh to really tick off the clutch/flywheel combo. I stage, the light goes green I an slipping the clutch in 1st gear for a 1.7 in the 60', the clutch pedal falls to the floor, I slammed it into 2nd and the car starts to bog out ... so I through it into 3rd and the clutch pedal popped back up and I just started to drive to the end of the track as the run was spent ... but then I realized the mustand in the other lane was catching up, so I floored in 3rd gear as he flew past me. I reeled him in really quick. Hyde actually went 79 mph in the 1/8 to 121 at the 1/4. Hyde went 13.2 @ 121 to his 13.6 @ 105. I dont think he was very happy about that ![]() I pulled around and Raul ran over. He asked what happened as the run was obviously botched. I told the clutch completely went out. He said, "So are you done? Do you want to pack up?" I said, "Nah, I'm gonna get in line with the slick/DR cars and get one more run." Since the slick/dr line does not move until all of the street cars are done, I figurred I'd have time to let the car cool off .... no dice. I jumped out of the car (first time all night) and they called us to the lanes! Back in the car I go, knowing this couldn't be good with everything so agitated in the drivetrain. The run: So I roll up and the burnout gets flubbed again (no surprise!). So I start to stage with a fire-breathing slick'd mustang in the other lane (listen to his engine road in the video). Love or hate them, there is just no denying that Mustangs can be very fierce. Anyway, regardles of my ET attempts, I've really been trying to get better at my reaction times.I had a .18 earlier in the night and a -.013 (talk about a close red light) and on the run against the mustang I redlit with a .082 to his .214. I had a 1.662 in the 60' to his 1.514. At 1/2 track we were real close: Hyde: [email protected] Mustang: [email protected] He was much quicker, but my GT35R was building speed at a much quicker rate. As I hit 3rd gear, I felt a bizarre hesitation in the acceleration. Apparently the turbo crept to over 33 psi for which we are not tuned. The map in the car is only tuned up to 26 psi and after that NoShoes has it pulling timing and adding fuel ... let me tell you, that is something you can feel. It was like trying to run in water. The final was: Hyde: [email protected] Mustang: 11.020 @ 122.36 Not a bad run for a bad clutch/flywheel combo and going flying off the tuning map. ... I can only wonder what it will do with a completed and the Tilton. It was an awesome race and he waited at the turn around to give me a big thumbs up. When I got back into my pit area he drove by and yelled that he works for Toyota ![]() I am now, 100%, done for 2006 ... really, I am done. No more. So here's the video: http://www.jekylhyderacing.com/image...0306_10943.wmv Here's the slip:
__________________
Sponsorship: Amateur Motorsports <-- Get the book! - books are now available for shipment |
|
#2
|
||||
|
||||
|
Re: 10.94 @ 129.8
I need off this mountain.
![]() Nice run!!!
__________________
1999 Pontiac Trans Am WS.6 #1747 Stock'ish' |
|
#3
|
||||
|
||||
|
Re: 10.94 @ 129.8
It's been a long time coming...congrats! You definately deserve it!
PS. I couldn't get any sound in the video?>
__________________
96 3000gt vr4 -K&N FIPK -Proboost mbc -Cusco front + rear strut bars -Greddy type-s -ATR downpipe -no cats -15Gs, 3sx aluminum pulley, FMIC, SAFC, walboro pump, EVO 560ccs, and Meth Injection Kit all waiting to go in shortly. Your 1996 Mitsubishi 3000GT VR-4 is the 92nd out of the 315 that were made that year. Only 21 of which are exactly identical. |
|
#4
|
||||
|
||||
|
Re: 10.94 @ 129.8
Congrats buddy.
You're falling right in line with the "standards". 7.00 1/8th = 10.90s, so yeah, that's about right.
__________________
**1966 Chevy II** ![]() 355 SBC, Turbo 400, 5.13 gear, IHRA Certified to 8.50 in the 1/4 Last Race (10-6-07) So its been awhile... Dial: 6.77, RT: -.0001, 60': 1.4360, 1/8th: 6.7942 @ 100.65 mph Fastest Pass of '07 (10-6-07) 60': 1.4360, 330': 4.3453, 1/8th: 6.7942 @ 100.65 mph 25 and in BIG TIME Debt Crew member #2 Deuce's Wild Racing: Take a Ride on the WILD SIDE
|
|
#5
|
||||
|
||||
|
Re: 10.94 @ 129.8
Finally... sheesh, now you'll stop crying about it.
![]() Nice run Jeff!
__________________
2003 Chevy 1500HD - Hauler 1971 Chevy Camaro RS - Track Car User Guidelines It's important to read, like the Bible. But unlike the Bible we will strike you down if you jerk off around here. |
|
#6
|
||||
|
||||
|
Re: 10.94 @ 129.8
Damn that's nice, congrats.
I just realized your using the GT35R, sweeeeet, they make my pants tingle.
__________________
![]() XBOX Live Gamertag: atxsbigwalt add me!! |
|
#7
|
||||
|
||||
|
Re: 10.94 @ 129.8
Mad MAxima, the GT35R changes the color of my pants
![]() Igovert500, I just DL'ed the vid and the sound works for me just fine?! Everyone, thanks ... I have to confess, I thought I was going to bust a tear when I got the slip, but I was simply too exhausted. This year has kicked my butt and back. On some level, I am glad to put the car away and not look at it for a couple of months. *sigh* ... time to relax.
__________________
Sponsorship: Amateur Motorsports <-- Get the book! - books are now available for shipment |
|
#8
|
||||
|
||||
|
Re: 10.94 @ 129.8
Congrats Jeff. I know you've been looking forward to this for a while. I just noticed that you're trapping higher in the 1/8th than ChevyTrucks
__________________
2001 Honda S2000 New Formula Red Mods: Engine: Comptech Air Intake Box, miscellanous chrome dress up pieces Suspension: Comptech front strut tower bar Exterior: Grillcraft grill, lots of wax Interior: Rick's leather console cover, Muz one-piece luxury floormats, Rick's windscreen, Electronics/Audio: Polk speakers Wheels/tires: 18" SSR Competition wheels with 225/40 and 255/35 tires
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|