|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Maintenance problems, fixes. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-13-2002, 10:24 AM
|
|||
|
|||
|
EGR valve replacement, HELP please :(
I just got my new EGR valve from Sewell Infiniti in Dallas TX. and I need to know how to install it, I see it clearly in my engine, looks as easy as two nuts and a rubber tube, but is there more to it? do I need to drain something, start the engine? or something like that?
thanx everyone
__________________
"Time aint nothing but time" 91 G20 5-speed manual, Stillen front strut bridge, Alpine 10" subwoofer/ 5 channel amp, APR DTM style 57" Aluminum racing spoiler, 2 and a half inch custom exhaust w/ high flow cat converter, Dual tip Arospeed racing muffler, custom smoked out parking lights, custom smoked tail lights, xenon gas filled super blue headlights, blue interior mood lights, neon light under dash, blue licence plate lights, some big ugly scratch dent put on there by some ignorant coward, but still, downright beautiful  
|
|
#2
08-15-2002, 10:24 AM
|
||||
|
||||
|
Just remove the old EGR and any gasket material, replace gasket if needed, bolt down new EGR connect vaccum hose and start car. Make sure it runs ok. Then shut it down and reset the ECU. Start car, make sure no EGR MIL code pops up and drive away.
__________________
Brandon '96 G20 - modified
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
