|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
11-23-2003, 11:41 AM
|
|||
|
|||
|
Problem removing resonator box during AEM Cold Air Intake Install...need advice
I am doing my very first mod and choose to install an AEM Cold Air Intake. I was crusing right along, got the old airbox, got the tire and splashguards off, then am stuck at removing the resonator box. Does anyone know if I have to completely remove the left-front headlamp, the bumper, to get box out? Right now it looks like it is hooked onto a single post under the headlamp, but I can't figure out the best way to get at it right now.
Any sage advice is greatly appreciated. 
|
|
#2
11-23-2003, 09:12 PM
|
|||
|
|||
|
Re: Problem removing resonator box during AEM Cold Air Intake Install...need advice
easiest way is to remove bumper cover.
there few clips at grill, six or so underneath, two bolt at bottom of bumper near wheels and two screws at wheels holding bumper to fender.
__________________
Power: Denso IK22 spark plugs, OBX Headers, J32A2 Camshafts, CT SC w/HB Electronics: Apexi VAFC (untunned) Gear Box: Rebuilt at 53K ml & at 63K ml by Aamco and still  Suspension: Eibach Sportlines, Koni Sport, Comptech Sway Bars & Neuspeed upper strut bar. Wheels: 17x7 OZ Racing Superleggara & 215/50 Dunlop Sport A2 Brakes: Legend GS 2 Piston Calipers, Goodridge SS Lines, Endless Nova Pads
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
