|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
08-22-2003, 10:03 AM
|
|||
|
|||
installing a new fender
I need to remove my passenger side fender and replace it with the new one i just purchased. I have all the bolts off the old one except the 2 under the black liner that goes from the front wheel to the back wheel. i tried unscrewing the black screws but only one was willing to be removed. all the others just spin in place. can you give me any advice on how to remove this liner or how to get to those 2 bolts so i can finish this job. thanks.
__________________
Peter Gibbons: I don't like my job and I don't think I'll go anymore. Joanna: You're just not gonna go? Peter Gibbons: Yeah. Joanna: Won't you get fired? Peter Gibbons: I don't know. But I really don't like it and, uh, I'm not gonna go. Joanna: So you're gonna quit? Peter Gibbons: Uh-uh. Not really. I'm just gonna stop going. Joanna: When did you decide all that? Peter Gibbons: About an hour ago. Joanna: So you're going to get another job? Peter Gibbons: I don't think I'll like another job. Joanna: Well what are you going to do about money? Bills? Peter Gibbons: You know I never really liked paying bills, I don't think I'm going to do that either 
|
|
#2
08-22-2003, 10:24 AM
|
|||
|
|||
|
those damn things what they are is plastic screws that strip out you need to hold then with a pair of plyers
__________________
95 b18b new crank, eagle rods, je 10.5 : 1 pistons, 8lb flywheel, stage 3 act clutch, billet aluminium and urathane mounts, balanced rotating mass, 14.3 @ 93mph New additions, teo4h turbo, ssautochrome turbo manifold, custom piping, turboxs bov, dsm 450cc injectors, greddy e-manage fuel controller 13.07 @ 107 untuned
|
| ||||||||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
