|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
08-14-2003, 08:00 AM
|
|||
|
|||
|
what length rods do i need
im getting either JE 12:1 or 11:1 B20 pistons for my soon to be bored out b18c1. my question is what length rods do i need???stock lenght?? and do i buy them for a B20 or B18???
|
|
#3
08-18-2003, 11:58 PM
|
|||
|
|||
|
K...you have a GSR motor, GSR crank, and B20 pistons...
Ideally, you want 84mm pistons for the b18c1. The small end of the rod is a little wider on the b20. You will need stock length rods no matter what, but you're going to have a little more play on the top end if you're using b20 pistons. Also remember that if the compression ratio was measured for a b20b head, it's going to be a bit higher in a GSR head.
|
| ||||||||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
