|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
hey gang. so I installed another 3.8 into my wagon. however, i get no spark.
it turns over fine. checked the coil well within range of use. swapped distributors. no dice looked at wires to plugs , nothing. there is absolutely no spark. however, i DID find a wire unplugged , but I have NO idea where it goes. dumb me forgot to photo journal the tear down the wire(s) are on the passenger firewall . the one bundle that runs into the Ignition control module has a smaller bundle. this is the one I cannot place. It stretches to almost all of the rear of the engine , but i cant find any orphaned plugs. btw, I did get a part number. e4eb14a464ga thats what is on the plug. it is grey and has two slots in it for a male plug. any help would be AWESOME. it s all i need to make this phoenix rise!! |
|
#2
|
|||
|
|||
|
Re: mystery wire upon install
ok, so mystery wire turns out it went to my A/C can...which has been removed. however, car still has no spark. im stumped...any help PLEASE!!
would airbag codes cause car to not start? I have fuel, just no spark |
|
#3
|
||||
|
||||
|
Re: mystery wire upon install
|
| ||||||||||||||||||||||||||||||||||||||
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|