|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
||||
|
||||
|
Aem Cai ?
Hey, i'm doing an ls/vtec swap into my 1995 honda civic dx coupe, i'm going to have a b16a2 head, b18b bottom end...which aem cai would i buy??? please help me out!
__________________
UGSTYLES |
|
#2
|
||||
|
||||
|
you would buy the CAI for the LS engine, not the B16 head.
|
|
#3
|
||||
|
||||
|
and will the intake still go down the small hole to place the filter behind the bumper??
__________________
UGSTYLES |
|
#4
|
||||
|
||||
|
No No No, buy the intake for the 99-00 Si. For one, it's the same setup as the 92-95 Civics and you have the B16A2 head which is from the Si so the throttle body will be from the Si and the intake will fit better. Again,you'll need it for the 99-00 Si, Trust me. Good luck.
|
|
#5
|
|||
|
|||
|
ya, you're replacing the whole top end of the motor. this means if you want to buy headers or anything on the intake side it will have to be for the b16a2.
|
|
#6
|
||||
|
||||
|
whoops..my bad..i keep on thinking that he just replaced only the cams..stupid me...:o
|
|
#7
|
||||
|
||||
|
so we are 100% positive that the intake and header should be for the 99-00 civic si dohc?
__________________
UGSTYLES |
|
#8
|
||||
|
||||
|
the inatke and headers should be for the car that donated the head.
__________________
hondaman-iac @ HondaStyle 92 ACCORD LX -- powered by a blown F22A1 Current Mods: *rear lower tiebar *AEM CAI *Koni Yellow Struts *Ground Control coilovers *Energy suspension bushing kit *front upper strut bar *rear upper strut bar PureHonda member since April 2001 |
| |||||||||||||||||||||||||||||||||
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|