|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
02-03-2005, 11:39 PM
|
|||
|
|||
alignment question
Hey Im looking for a alignment tool that would so simple toe in/out alignment.
http://cgi.ebay.com/ebaymotors/ws/eB...sPageName=WDVW Is this tool good? Tom 
|
|
#2
02-07-2005, 03:45 AM
|
|||
|
|||
|
Re: alignment question
In all seriousness...a tape measure will get you very close.
__________________
Remember: Don't confuse noise with horsepower! and Junk is junk, even when it's on sale! "I would never doubt your expertise....it's obvious you wrote the book on stupidity!" DD
|
|
#3
02-07-2005, 11:52 PM
|
||||
|
||||
|
Take a string, tie it to a jackstand or other anchor. Starting at the front drivers side, take the string back to the rear tire, go around the back of the tire to the other side, around the back passenger side tire, then to another anchor at the front passenger side. The string should be near the mid point of the tire; not way up and not near the ground.
Now you can scoot the jackstands in until the string touches outward most edge of the front tire's sidewall. Use a tape measure to measure from the string in to the tire on both sides.
__________________
Dragging people kicking and screaming into the enlightenment.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
