2.4 cam timing

comp · #1 01-23-2004, 06:51 AM

i see this site does get a lot of action but; HAS ANYONE FOUND OUT THEIR CAM TIMING WAS OFF FROM THE FACTORY? shot in the dark

Anaudiophile · #2 03-09-2004, 01:16 AM

Hmmm........not very likely, but could be possible. If it was out even one tooth on one cam, you'd notice quite a difference in driveability!!

comp · #3 03-09-2004, 11:24 AM

my dad's is a full 1-1.2 seconds slow 0-60 mph ??? you can feel torque
band start then the computer shifts and you feel it start to come on and it shifts again

Bigs30Abone · #4 01-11-2005, 05:52 AM

Unlikely that the cam timing is off but would not hurt to check it. You can also put a vacuum gauge on car, if cam is out vac will not be what it should at idle.

comp · #5 01-11-2005, 07:07 AM

they have put 20k on in and it's out of warrenty now

Thread Thread Starter Forum Replies Last Post

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2003 eclipse 2.4 cam crank codes check engine light	polarisxcr	Eclipse 2000+	9	08-02-2012 05:39 PM
2.4 blowing black smoke	cr_rider	Mighty Max	5	12-31-2010 02:56 PM
2.4 cam actuator valve change	jim krisher	HHR	1	12-14-2010 02:16 PM
Nissan Quest V6 to 2.4 ltr 4 cylinder swap	Scraped Knuckles	Quest \| Presage \| Serena	4	02-20-2009 08:59 AM
Honda Passport 4-cam timing problems	olderguy	How-To's and Walk-Through's	3	02-04-2006 01:20 PM

POST REPLY TO THIS THREAD