|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#16
|
|||
|
|||
|
Re: 1996 200sx se questions
The 200sx 1.6 is not an SR. It is a 1.6 liter GA16DE. You need alot more parts to convert it to the 2.o. B14 SE-R Wiring Harness, SE-R heater Hoses, Axles, Axel Carrier Bracket, Passenger side bracket, rear mount bracket, SE-R radaitor, SE-R Tranny, SE-R Flywheel, and the SE-R clutch.
|
|
#17
|
|||
|
|||
|
Re: 1996 200sx se questions
dont need the radiator and the heater core hoses and the rest is simple. same shit you need for the Bluebird you need for the Gti-r thats all i am saying. i have done this swap in a 97 200sx se and a 91 sentra 4 door 1.6. all that stuff that you mention can be had from your local junk =yard for little and nothing. and me being a part of one of the biggest se-r/ nissan clubs in the northeast helps. check the website www.teamserious.com there are at over 20 swaps from 1.6-gtir, 1.6-BB, 2.0-20VE and 2.0-1.6VE, 240-rb25/rb26 etc.
|
|
#18
|
|||
|
|||
|
Hey guys, check out this website for your swap.. it may save you lots of headaches... www.totaljdm.com. These engines come with the ECU, HARNESS (extra $100), TURBO AND INTERCOOLER. All else you will need is the trans, mounts and drivetrain (try searching junkyard websites -- lots of them have inventory systems you can search). Then you could be a short drive and the help of a few friends away from a successful swap.
I have the SR20DET GTi-R swap planned and scheduled for next summer. I have an SE-R so it will be a little easier for me. Though I'm very intrigued by the fact that the engine comes with the 4WD transmission and I might step up to the challenge of converting it to 4WD instead of just throwing my old trans onto it. Anyway, good luck, hope this helps. |
|
#19
|
|||
|
|||
|
Re: 1996 200sx se questions
i did the swap it was fun... learned a lot just go for it and have fun...also if need got and sr20de ecu for sale...
fredo
__________________
1994 4 door BBDET auto - manual swap club 16" enkei rims,3'' custom cat-back ,5zigen muffler, GC coilovers, KYB AGX adjustable shocks, drifter bodykitwww.ClubNismO.com |
|
#20
|
|||
|
|||
|
Re: 1996 200sx se questions
What do u guys think a 96 200sx manual with a cat-back exhaust and cold air inake would run in the 1/4 mile? and what about 0-60? also whats the stock HP off one of these? and what do u think it is with the upgrades?
__________________
|
|
#21
|
|||
|
|||
|
Re: 1996 200sx se questions
well assuming that your talken about the se-r (i have one with a catback and cold air and alot of other stuff for sale) the se-r runs a 15.6@91Mph stock and a lil over 140 hp ... with what i've done to my car i'm prolly only putting out 180 hp but i run about a 14.3(was my average 2 weeks ago) and it wasn't expensive to make it fast
__________________
Needs A Det!! |
|
#22
|
|||
|
|||
|
Re: 1996 200sx se questions
not quite sure, its my friends car, he was just wonder what kinda hp he had
__________________
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|