|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
10-06-2003, 09:56 PM
|
|||
|
|||
|
Help with my swap please!
I swapped out my d16 for a b16, now i swapped my b16 for a b18, however i cant get the b18 to run. i get spark, gas, air, the fuel pump turns on, it turns over, but doesn't want to start, iv put all the grounds back on, but i feel that i may have missed a couple, i onyl put the tranny one on and the valve cover one on. i'm running a p72 ecu, hoever there are 2 wires and one plug running from my ecu to the engine bay, one goes to the vtec solenoid, and the sensor connects to the senors on the back of the block, under the intake manifold. what am i missing, i replaced the cap and rotor, with 94 integra ls/gsr parts, and got gsr wires/plugs. any ideas, please help, i need to get this thing going
Thank you in advance Mike 
|
|
#2
10-06-2003, 09:58 PM
|
|||
|
|||
|
oh ya.. timing is correct also
|
|
#3
10-07-2003, 06:31 AM
|
|||
|
|||
|
anyone? please
|
|
#4
10-07-2003, 06:20 PM
|
|||
|
|||
|
no one knows anything about swaps hjere?
|
|
#5
10-07-2003, 06:36 PM
|
||||
|
||||
|
Well in theory if you have spark, fuel and compression your car will run. You must not have one or all at same time. Do you even get a pop when it tries to start? Try giving it a quick squirt of starting fluid and if it pops then your injectors aren't working, or not enough fuel pressure or at least a fuel related problem.
__________________
[size=1/2]96 Civic CX Hatch 1.6 Non VTEC Full length CAI Custom Catback Exhaust Short throw H&R stage II springs Tokico Illumina adjustables front upper,rear upper,rear lower tie bars ST front and rear sway bars BOOSTED![/size]
|
|
#6
10-07-2003, 07:03 PM
|
||||
|
||||
|
Hey u wanna get rid of the b16 u took out?
__________________
-Andrew- 
|
|
#7
10-07-2003, 08:29 PM
|
|||
|
|||
|
well i'm thinking of trying that, and abot the b16, all i have left is the JDM b16a tranny, with an ITR final drive gear, pistons, an ITR intake manifold, and other random components
|
|
#8
10-07-2003, 10:08 PM
|
|||
|
|||
|
I found that the injectors arnt opening, if i find them to be good, what can i do about wiring, or what does it mean?
|
|
#9
10-07-2003, 10:40 PM
|
||||
|
||||
|
check the fuel line from the passenger side. My friend had his in the wrong spot and it wouldnt run either. Just a thought...
__________________
2004 Sonic Blue Ford Ranger XLT 2001 Liquid Grey Metallic Ford Focus ZX3 1995 Integra GS-R - Parting out
|
| ||||||||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
