Top Studio Chain

[AKA TC]

I'm finishing up my rc211v and need to build the Top Studio chain and am unclear about building the jig tool. Would you guys happen to know how many part number 1,s are glued together. The PE comes with like four but the picture shows only two glued together. And did you guys glue one side with clear glue to hold the links in place while building like the website shows? I would love some help as I have three chains. Thanks..

[andrew59it]

Originally Posted by AKA TC

I'm finishing up my rc211v and need to build the Top Studio chain and am unclear about building the jig tool. Would you guys happen to know how many part number 1,s are glued together. The PE comes with like four but the picture shows only two glued together. And did you guys glue one side with clear glue to hold the links in place while building like the website shows? I would love some help as I have three chains. Thanks..

Did you check at top studio site
http://www.topstudiohobby.com/

under tips->chain making

It could help...

[AKA TC]

The site shows the tool but does not show its construction. I guess I could try two part ones glued together and see if its wide enough. Anyone? I know people have built them here. Thanks..

[andrew59it]

Originally Posted by AKA TC

The site shows the tool but does not show its construction. I guess I could try two part ones glued together and see if its wide enough. Anyone? I know people have built them here. Thanks..

It seems not so difficult. Have you the instruction into the chain set? There are 4 pieces to sandwich together, 2 òarger outside and to thinner inside. You have to place 2 screws at either ends of the tool and 3 piece of 1 mm soldering line to squeeze into the 3 holes of the tool.... If you need instructions I may send them to you.