|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
04-16-2003, 02:06 PM
|
|||
|
|||
|
Clearing Corners
I drive a 96 Blazer, and I'd like to clear out my corners on the composite headlight assemblies. This proves difficult, if I don't bake my enclosures, because they are sealed, and I don't know a better way of removing the front off of them, so that I can pull that orange reflector out. Anyone have any suggestions as to how I can do it, or how they did it, even? Any help is appreciated.
__________________
 http://www.sounddomain.com/id/superdawg AIM ID: aSuperDawg 
|
|
#3
06-28-2003, 12:21 PM
|
|||
|
|||
|
Yeah. I have a haynes manual. I have a hair dryer that I can try, but I don't want to risk ruining the headlights. Well, ultimately you run the risk of ruining anything, when you try anything. I want to run the least amount of risk, actually. I can't afford to ruin them, as this is my daily driver, and I can hardly even go half a day without them...
Any help is appreciated.
__________________
http://www.sounddomain.com/id/superdawg AIM ID: aSuperDawg
|
|
#4
06-30-2003, 06:03 PM
|
|||
|
|||
|
Other than telling you to check out your Haynes manual, I'd have to wait till I get back to the states and check my blazer out to see if I can be of any further help. If that manual can't be of any help, maybe someone else on here can.
|
|
#5
07-08-2003, 11:49 PM
|
|||
|
|||
|
Maybe this will help
__________________
-= DJ Nitrous =-
|
| ||||||||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
