|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
2000 3.0 24v hard to start wagon.
My 2000 3.0 24v wagon is difficult to start about 75% of time. In the past year
have replaced the fuel pump, crank position sensor, and camshaft position sensor. The problem happens for cold and sometimes warm starts both. Engine runs fine after starting. Running out of options, any help? Thanks |
|
#2
|
||||
|
||||
|
Re: 2000 3.0 24v hard to start wagon.
Welcome to the forum!
Have you tried holding the throttle slightly open when starting? Maybe the throttle plate is carboned up and/or the IAC is not functioning properly. Also, what is the fuel pressure when the car won't start easily? -Rod |
|
#3
|
|||
|
|||
|
Re: 2000 3.0 24v hard to start wagon.
Thanks for the response.
I have checked and cleaned the IAC, and the entire throttle plate/body mechanisms. The pressure bleed valve ejects a strong stream of fuel from the fuel line although I have not done a pressure check. The fuel pump was one of the first things suspected and replaced some time back. Last edited by Tglass; 07-07-2009 at 01:20 PM. Reason: misspell |
|
#4
|
||||
|
||||
|
Re: 2000 3.0 24v hard to start wagon.
Quote:
Were you parts you mentioned in your original post all replaced because of this issue? -Rod |
|
#5
|
|||
|
|||
|
Re: 2000 3.0 24v hard to start wagon.
Ok, I'll get a guage and check the pressure.
Can't be certain so I'll have to check, but I believe the filter was changed. I did not do that job myself. The others I did. Thanks again Tom |
|
![]() |
POST REPLY TO THIS THREAD |
| Tags |
| 24v , 3.0 , hard , starting , wagon |
![]() |
|
|