|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
06-14-2009, 10:40 PM
|
|||
|
|||
|
C-4 Vette wheels
Got some C4 corvette wheels I want to use on my 80 Elky. 8.5 wide on the front, 9.5 on the back, rear backset requires a 2 inch spacer to get clearence from the frame, problem is this puts the outside about an inch outside the fender. Beside the obvious frame work anybody know any tricks to get em in the fenders?
|
|
#2
06-15-2009, 12:35 AM
|
|||
|
|||
|
Re: C-4 Vette wheels
Roll the fenders out? thats alot though. A good body shop might be able to get the fenders out there for less than the cost of doing frame work. Thats the only problem with G-bodies, other than that the platform is about perfect.
__________________
 1980 El camino 2002 LS1 swap
|
|
#3
06-15-2009, 06:51 AM
|
|||
|
|||
|
Re: C-4 Vette wheels
Thanks for the reply, guess I will have to flip a coin to see weather the frame goes in or the body goes out. In factory trim I guess an 8 inch wheel is the widest that will fit?
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
