|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
95 accord f22b2 can't access trouble codes
ok i pulled the 2 pronged blue plug to see if there's any trouble codes stored in the ECU...
when i put a jumper wire (paper clip) as described on: http://www.troublecodes.net/honda/ the SRS light flashes constantly instead of going into the CHECK engine light flashing codes before a year ago or more, it flashed me a bad o2 sensor code & i replaced it... now, they're having some intermittent problems and i want to access the car's ecu to see if any codes are stored... one guy told them it may be the TPS any help would be great |
|
#2
|
||||
|
||||
|
Re: 95 accord f22b2 can't access trouble codes
As far as I understand if your check engine light is not on, there are no codes stored in the ECU.
Considering the age of the vehicle it might be a poor contact. Intermittent problems are the worst to deal with! Wait for the code to lit the check engine light and then check it out. Good luck, Sam
__________________
Quote:
|
|
#3
|
|||
|
|||
|
Re: 95 accord f22b2 can't access trouble codes
thanks, Sam...
so that mechanic was just throwing a dart at their idling problem... I'll just advise them to change out the plug wires, cap, rotor, (plugs were done recently w/ the timing belt-water pump job) and possibly the fuel filter since it looks original
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|