97 PA driver's side power window

[Holaday1185]

Hey all,

My driver's side power window has been acting up quite a bit lately. The window goes down fine, but when you push the button to get the window to roll back up, it goes super super slow. After about 3/4 of the way up, I have to manually push the window up while, at the same time, pushing the button. About 3 years ago I replaced the motor on this window. Also, I removed the panel today to check for any obstructions and found nothing. Any ideas? Thanks.

[HotZ28]

but you may need to replace the motor again, that is about the only advice we can offer.

[Holaday1185]

So window motors just don't die? They die slowly??? Slightly confused here. What causes one to "die over time?"

[Scrapper]

Originally Posted by HotZ28

but you may need to replace the motor again, that is about the only advice we can offer.

that should run off a cable it could be strecthed or take door panel off see if it's the switch,cable or motor. it may just need lubed.

[Holaday1185]

I took the panel off the other day and lubed everything that I could get to. Any other ideas?

[Holaday1185]

Just to recap--- window has been acting better lately. Some days it is reallyyyyyy slow, and other days it's just normal. Any ideas still??

[ZiggyPA]

Sounds like a bad ground or contact somewhere?

[Holaday1185]

Hmmm. To be honest, I'm not so sure what I am looking for. Any ideas?