|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-16-2009, 06:31 AM
|
|||
|
|||
|
redundant controls
Has anyone attempted to replace the bulbs in the redundant controls on the steering wheel? I'm assuming they are bulbs. How do you remove the buttons? I have one burned out and figured I'd ask before I start digging at it. Thanks.
|
|
#2
03-16-2009, 07:14 AM
|
|||
|
|||
|
Re: redundant controls
I worked at the dealer, we always replaced the buttons, but they were always warranty to. I don't think however that you can get them apart, if I remember right they are plastic welded, not snapped together.
__________________
10 hours away from John Deere master certified also master certified ASE tech. Exp. in both. Went to school for cars, wound up staying with Deere dealer for a while, so schooling there too. Also couple years exp in GM and some GM training Gave up wrenching for "Greener Pastures" Current job: RN 2010 Silverado Z71 5.3L 65xxx Wife's 2007 Suburban 1500 LTZ 5.3L 102xxx
|
|
#4
03-16-2009, 10:27 PM
|
|||
|
|||
|
Re: redundant controls
Just work around the edge with a small flat blade, or oring pick, they are just held in by tension, ie small hole, large piece, there are no clips etc, they just pull out, just got to get ahold of em.
__________________
10 hours away from John Deere master certified also master certified ASE tech. Exp. in both. Went to school for cars, wound up staying with Deere dealer for a while, so schooling there too. Also couple years exp in GM and some GM training Gave up wrenching for "Greener Pastures" Current job: RN 2010 Silverado Z71 5.3L 65xxx Wife's 2007 Suburban 1500 LTZ 5.3L 102xxx
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
