|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
Shake when braking
I got a 87 4x4 Toyota pickup that will shake very bad during normal braking. I've adjusting my driving to work around it. I had the front rotors turned, didn't help. Put new rotors and brake pads on the front and new brake shoes on the rear, didn't help. I tried to check the ball joints for excessive wear. I didn't see or feel any movemeent during this check. Not sure what to check next. Any help what be appreciated. Thanks.
|
|
#2
|
||||
|
||||
|
Re: Shake when braking
Try the tie rod ends for play and for tires out of balance. Raise the wheels off the ground to check the ball joints. Finally, make sure the rear brakes are adjusted to properly carry some of the braking load. Letting only the fronts do all the work causes them to heat up excessively and cause warpage. Good luck!
__________________
Current Garage: 2009 Honda CR-V EX 2006 Mazda 3i 2004 Chevrolet Silverado 2500HD 2003 GMC Envoy XL 2000 Honda ST1100 2000 Pontiac Sunfire Vehicle History: 2003 Pontiac Vibe AWD - 1999 Acura Integra GS - 2004 4.7L Dakota Quad Cab 4x4 - 1996 GMC Jimmy 4wd - 1995 Chevrolet C2500 - 1992 Toyota Camry LE 2.2L - 1992 Chevrolet S10 Ext. Cab 4.3L - 1995 Honda ST1100 - 1980 Yamaha XS400 - 1980 Mercury Bobcat. |
|
#3
|
||||
|
||||
|
Re: Shake when braking
Check/re-check things that wear in the front end; bushings (control arm, sway bar, etc), idler arm, pitman arm, ball joints, TREs, wheel bearings.
__________________
84 4Runner - ARBed 5.29s F&R, 4.7 & 2.28 t-cases, Chevys, AP x-over, BudBuilt x-member, 2" drv trn lift, 36" TSLs, 30 spline Longs 80 something p/u - Buick 231 V6/TH-350 trans, Holley 4 bbl, Weiand intake, dual batts, dual tanks ... 89 4Runner - stock 2000 Isuzu Trooper + 2010 Sonata |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|