XS Tuning Rims

[Blackout]

I was just wondering if anyone here has used the new rims from XS tuning? I see that they aren't very big, but Im curious how wide they are compared to a set of Fujimi rims.

[Corradog60]

I ordered 4 sets. Compare to Fujimi's aftermarket rims, they are quite small. They are good for 1/25 but too small for 1/24. I think they are just same as the Fujimi's original rims. NOT TOO BIG. If you are looking for rims for aftermarket look, think of Fujimi. But if u are looking for rims for smaller model cars, they are good enough.


:flash:

[Honoturtle]

They aren't so bad, I like how the wheels aren't too tall (the walls), I already converted my Civintegra to take "male" rims, but if you do buy them, then you hate them, at least it comes with two sets of drilled disk brakes!

[Corradog60]

Totally agree with U, I ordered them because of drilled disk brakes!

But I really didn't know they are so small..

:flash:

[supratuner]

i have some of these wheels
and ive been looking at them thinking they are small, but i have come up with this? the wheels on most tamiya cars seem tob e a little big, mostly just too wide, i think these are more down to scale than most other after market wheels IMO

[Blackout]

so then they should be fine for the Revell models ( Civic's, Integra, Datsun 510). I want to put aftermarket rims on, but obviously the Fujimi's just dont work, unless you do some serious cutting.