|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Problem Diagnosis Got a problem you can't fix? Post here and one of our members will answer as soon as possible. |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
1993 Blazer Idle Issue
I have a 1993 chev Blazer 4.3L Vortec "W" series. When I pull up to a red light or stop sign, the truck idles good for about 10seconds than starts to idle really rough and shake violently. Upon take off it sputters like fuel starvation or a bad misfire than takes off. The list of things that have been replaced is quite extensive.
-Spider Injection Assembly, lines & all (Replaced about 40k ago) -Fuel pressure regulator (Replaced 3k ago) -EGR (Replaced 40k ago) -Fuel Filter (Replaced 5k ago) -Fuel Pump (Replaced 20k ago) -New plugs, cap & rotor (Replaced 20k ago) I went ahead today and changed plug wires with some Delco''s, air filter cause it was due time to be done anyway and saw that the air temp sensor in the air intake tube was all gummed up so I cleaned it with some CRC carb cleaner. Well not only did none of what I did make any difference but now the service engine light is on. WTF? I also noticed that on the drivers side right below the middle plug wire there is an electrical plug that is cracked. Any ideas why now the engine light is on as well? |
|
#2
|
|||
|
|||
|
Re: 1993 Blazer Idle Issue
the burned connector is a nox sensor..i had the same thing....check your cap..all my electrodes were burned...in only 6 months too...
|
|
#3
|
||||
|
||||
|
Re: 1993 Blazer Idle Issue
That's the knock sensor.
|
|
#4
|
||||
|
||||
|
Re: 1993 Blazer Idle Issue
Check codes and post back code no.
__________________
Remember proper testing gives us the answer to many problems. MT |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|