|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
08-05-2008, 09:40 PM
|
|||
|
|||
|
Brake pressure switch Connection
I just purchased the "brake repair kit" to replace the brake pressure switch in my 1995 Wondstar. I have no Idea where the connection on the other side of the assembly fits. I know that the design has changed on the master cynd side but I do not know where the other side fits. IT is part of the cruise control i believe?
Thanks Michael 
|
|
#2
08-06-2008, 06:11 AM
|
|||
|
|||
|
Re: Brake pressure switch Connection
The other end of the wire harness that came with the new switch connects to the connector that was originally connected to the old switch.
I have some pictures posted in the pictures that the link in my signature takes you to that show the brake pressure replacement on my '96. I don't know if it will help or not in finding the other end.....if it has become hard to find.
__________________
Moderator for Ford Windstar room only Links to my pictures, intended as an aid, not a replacement for, a good repair manual. 1996 3.8L Windstar http://www.flickr.com/photos/4157486...092975/detail/ 2003 Toyota Sienna pictures (not much there yet) http://www.flickr.com/photos/4157486...781661/detail/
|
|
#3
08-06-2008, 06:58 AM
|
|||
|
|||
|
Re: Brake pressure switch Connection
On my 95 the two wires leading away from the switch from the master cylinder clearly lead into a larger wire harness and follow the wires up around the wiper mtor i believe with no old connector in sight.
I doubt that they would have changed the configuration since other people in the forum report successful installations on their 95 models. Michael
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
