|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
06-15-2008, 11:13 AM
|
|||
|
|||
|
Header install
I have bought the pace setter header system for my 89 4.0 w/auto tranny. I was wondering if anyone has installed this before, and if there are any problems or mods that I may have to do to install this correctly. I ahve already cleaned the intake and all ports. will replace the EGR, (150K) I have purchased the manifold gaskets from napa for the manifold and cat flanges, the gaskets offered look cheap.
|
|
#2
06-15-2008, 01:23 PM
|
||||
|
||||
|
Re: Header install
I didn't go this route when I did my 88, based on what I found while googling around.
The exh flange is a bit thinner than the intake. Make sure you use the stepped washers they provide. The O2 sensor mounts in a different location. You'll need to extend the harness. Some reported the fit is pretty sloppy and needed a bit of persuasion to get the pipes all together. Others reported leaks. However, many report getting everything together OK, and working out fine.
__________________
Dad's taxi: '88 XJ - 190K and going strong. K&N, Ford Injectors, No other mods
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
