|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-11-2008, 06:35 PM
|
|||
|
|||
|
Me Again..
Ok....i Ahve Redone The Bolts On The Intake And Heads With Threadlock....will Mi Harm The Engine If I Turn The Motor Over Without It Cranking After I Drain The Oil To Make Sure All The Milky Oil Is Out?
|
|
#2
03-11-2008, 08:50 PM
|
||||
|
||||
|
Re: Me Again..
Do Not Drain The Oil And Then Crank It Over. You May Damage A Bearing. Only Crank The Engine When There Is Oil In It.
__________________
1988 9C1 - Modified LM1 @ 275HP/350TQ - TH700R4 - 3.08 8.5" Disc Rear - see it at http://www.silicon212.org/9c1! 2005 Crown Vic P71 - former AZ DPS - 4.6 liters of pure creamy slothness! 1967 El Camino L79/M20 old school asphalt raper Remember - a government that is strong enough to give you everything you need, is also strong enough to take everything you have.
|
|
#3
03-14-2008, 08:46 AM
|
||||
|
||||
|
Re: Me Again..
if you do it by hand (pair of vicegrips on the flexplate) it shouldnt be a problem
also if you have problems with getting the bad oil out pour about half a quart of tranny fluid in drive it about 50-100 miles then change oil again
__________________
If you cant find a hole make one
|
|
#4
03-15-2008, 12:09 PM
|
|||
|
|||
|
Re: Me Again..
or go and buy 2 gallons of oil.
fill it. turn it over and run it for a few minutes. drain oil. repeat.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
