|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-06-2008, 10:22 PM
|
||||
|
||||
|
Help installing Gauges
Hey im trying to install a Water temperature gauge and an oil temperature gauge im not to sure where the sending unit on these things go?any ideas would be great and if you have pics that would be even better. Thank you... also how do i go about installing a mechanical Oil pressure gauge as well. thanks again
__________________
my Cardomain 2002 3.4L V6 GA Coupe  ------------------- -Xero is my hero-- ------------------- mods: Suspension: KYB GR2s, Intrax Lowering Springs, Upper Front Strut Bar Engine: Custom 2.25" Exhaust,Doctorspeed Cold Air Box 
|
|
#2
03-07-2008, 06:23 PM
|
||||
|
||||
|
Re: Help installing Gauges
You will have to run them to the ecu... I dont have one, but you will need to find a wiring diagram for your car's ecu amd run the wires to the apropriate places...
__________________
97' Eclipse RS 5 Speed 420A Under The Hood: Bomz UDP, Custom CAI, NGK Plugs, Mopar Wires Interior: Blue Glow Dash Guages & HVAC Controls, Neon Accents, Custom Dash Work\Paint, Alpine Type-R/JL Audio System, Custom Trunk Layout *GOAL* - Prove Him Wrong Quote: Originally Posted by UnderEstimate Me I doubt bolt-ons will get you to 160hp on the 420a. Unless you have some dyno sheets Im calling bs.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
