|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
02-14-2003, 05:23 PM
|
||||
|
||||
|
Rings?
I've decided to turbo my D16A6, and put a Y8 head on it with Arias pistons, Eagle Rods, but I don't know any good companies that make rings. What would you guys recommend. The block is going to be sleeved, so should I do full seal rings or what?
Nick
__________________
1991 Sedan LX Auto (Auto2Manual / MPFI / OBD1 conversions complete) www.naytontech.com :: youtube.com/naytontech 
|
|
#2
02-14-2003, 05:51 PM
|
||||
|
||||
|
what rings did arias recomend? Unless their oversized I'd personally use stock rings. But get more opinions and ask in the tech section.
__________________
"shut the door Joshua, and let death pass by..."
|
|
#3
02-14-2003, 08:02 PM
|
||||
|
||||
|
i wouldnt go with a mini-me setup if i was you, there notorious for overheating, and being VERY unreliable, sure its more work, but i say go with the whole y8, or better yet (less work) go with the z6, there almost the exact same engine, and i dont think the extra work is worth the 1 extra hp. and 1 extra ft. lb of tourque
__________________
94 Integra LS, autotragic, Tons of mods 93 Accord wagon, Manual conversion and f20b swap in the near future!
|
|
#4
02-14-2003, 08:57 PM
|
||||
|
||||
|
I have to agree i have heard about the mini me swap over heating...and it so easy to swap in a Z6/Y8.....and unless you go over sized pistons i would use stock rings...if you do go over sized ask the piston maker what they recommend...
gunnmen01
__________________
My other ride..... is YOUR MOM !!!!!! 
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
