|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
12-15-2002, 07:36 PM
|
|||
|
|||
|
scratchbuilt exhaust headers
I'm interested in making some exhaust headers out of aluminium tubing. I understant I can mount it on a drill and polish the tip with sandpaper to make it sharper.
However, how would I do this if the header tips are not flat but oblique?
__________________
Recent stuff:  Singapore scale modeling site at http://machinemess.singaporeanimenews.net 
|
|
#2
12-16-2002, 04:29 AM
|
||||
|
||||
|
I assume that you will start with round tube and then gently squeeze it flat? So therefore you could thin out the wall before making it oblique.
P.S. Do you want to sell your 250 GTO ?, I just need the engine..... 
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
