|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
12-07-2007, 12:20 PM
|
|||
|
|||
Does anybody have?
Hi there Does anybody have a 1995 Mitsubishi Eclipse GST 4G63 engine block (Turbo) that they can sell me this block look's DIFFERENT then the one's I seen in ebay here are some pic's
  
__________________
  
|
|
#2
12-07-2007, 12:34 PM
|
||||
|
||||
|
Re: Does anybody have?
Is that the block you had to go in your car? Where did it come from?
__________________
98 Eclipse GS Turbo Megasquirt 2 - Holset HY35 Turbo - Built motor - P&P Head and Intake - 3" Turbo back - FMIC - Greddy RZ BOV - Walbro 255 - Aeromotive AFPR - 650cc Injectors - Fidanza Flywheel - Zoom clutch - 13" Cobra Front Brakes - AEM WB - Devilsown meth injection - 3.55 Final Drive gear ratio 1981 Chevy Scottsdale 1987 Nissan 300zx - Chump Car 2001 BMW 325i - DD
|
|
#3
12-08-2007, 01:22 AM
|
|||
|
|||
|
Re: Does anybody have?
Quote:
 Yes that block came with the car & it was runig but it had a knocking noise inside the ingine.  I don't know if it's an American engine or a Japanese engie because I bought one in a shop & the guy toll me if my engine was a American or a Japanese engine (it wasent the right one) so I don't know if somebody can tell me how to fine out what kind of engine it is please let me know . On the block has this #'s 4G63 RP1047
__________________
|
|
#4
12-08-2007, 08:13 AM
|
||||
|
||||
|
Re: Does anybody have?
I thought they only manufactured the 4g63 in America?
__________________
-Brian
|
|
#5
12-21-2007, 07:44 PM
|
||||
|
||||
|
Re: Does anybody have?
Quote:
Nope
__________________
Current Cars 2006 Eclipse GT 6 speed MT (V6 3.8), mods so far- S Tech Springs, after market 18's, 2012 headlight Conversion, Greddy cat back exhaust, CAI, RRE Headers, Polyurethane Motor Mounts, NX Nitrous kit at 100 shot for now, RPM Window Switch, Triple Pod. 2003 Grand AM GT - official beater car for the winter lol ---------------------------------------------------- 95 TSI AWD [email protected] (T-25) Now fully Modded engine with 3,560 miles on it.SOLD
|
|
#6
12-22-2007, 09:46 PM
|
||||
|
||||
|
Re: Does anybody have?
Quote:
__________________
97' Eclipse RS 5 Speed 420A Under The Hood: Bomz UDP, Custom CAI, NGK Plugs, Mopar Wires Interior: Blue Glow Dash Guages & HVAC Controls, Neon Accents, Custom Dash Work\Paint, Alpine Type-R/JL Audio System, Custom Trunk Layout *GOAL* - Prove Him Wrong Quote: Originally Posted by UnderEstimate Me I doubt bolt-ons will get you to 160hp on the 420a. Unless you have some dyno sheets Im calling bs.
|
|
#7
12-23-2007, 01:37 PM
|
||||
|
||||
|
Re: Does anybody have?
Yeah, actually Brian, if my memory serves all 6 bolts were made in Japan and in late 92 when they switched to 7 bolts those were made here in the states. I actually read an article that blamed CW on that fact.
__________________
 Build on hold until I get a good paying job, either in school or once I get out. At that time a full tear down and complete rebuild should be in order. The Purple People Eater will ride again... January 2011 can't come soon enough.
|
|
#8
12-24-2007, 02:45 PM
|
||||
|
||||
|
Re: Does anybody have?
Yeah a lot of 4G63s were produced in japan because they put them in the GVR4s over there along with the EVOs
__________________
1998 Eclipse GSX 6 Bolt swap MHI Big 16g FP Race Manifold Apex'i N1 Cat-back Apex'i N1 Downpipe Walbro 255 fuel pump GReddy Type S BOV Turbo XS Boost Controller Balance Shaft Elimininator ACT 2600 RRE 11lb No Name Flywheel Prothane Motor Mounts Tokico Illuminas Advanced Handling Kit RRE Front and Rear strut tower bars RMDSM Front and Rear Sway Bars TRE Stage 2 Tranny ARP Head Studs, Main Studs, Rod bolts
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
