|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Problem Diagnosis Got a problem you can't fix? Post here and one of our members will answer as soon as possible. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#2
10-22-2007, 11:59 AM
|
||||
|
||||
|
Re: S10 Heat Gauge
With the engine cold, make sure it's full of coolant now. Sometimes it takes a few days to settle out all the air.
Sudden weather cooling will activate extra thermostat activity too. 
|
|
#3
10-22-2007, 07:34 PM
|
||||
|
||||
|
Re: S10 Heat Gauge
Did you experience these symptoms before the radiator and thermostat were replaced? How much fluctuation is there, (how many degrees)? Air in the system, as Chris mentioned, is a very real possibility.
|
|
#4
10-24-2007, 12:48 PM
|
|||
|
|||
|
Re: S10 Heat Gauge
This Problem , Started When We Put All The Sensers On This Truck, An New Fuel Pump An Comp. An New Timeing Chain An Gears.then We Put New Cap, Rotor An Module. Then We Put A New Thermaste In Cause We Had Water Pump Off When We Replaced The Timeing Chain. It Isn't Hot The Gauge Just Goes Way Up An Then Kinda Up An Down. Just Don't No Why. Debs10
|
|
#5
10-24-2007, 06:39 PM
|
||||
|
||||
|
Re: S10 Heat Gauge
An open circuit will cause the needle to go to full hot. There may be a loose connection somewhere, check the connection at the temperature sensor first, make sure it's clean and tight.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
S10 Heat Gauge
