|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#2
10-20-2007, 10:24 AM
|
|||
|
|||
|
Re: Thread size in Shredder valve
I have no idea, but I did misplace the cap for the one on my '96, and a tire valve cap fit just fine.
__________________
Moderator for Ford Windstar room only Links to my pictures, intended as an aid, not a replacement for, a good repair manual. 1996 3.8L Windstar http://www.flickr.com/photos/4157486...092975/detail/ 2003 Toyota Sienna pictures (not much there yet) http://www.flickr.com/photos/4157486...781661/detail/ 
|
|
#3
10-21-2007, 09:23 AM
|
|||
|
|||
|
Re: Thread size in Shredder valve
jeffk388
Are you trying to make a make shift fuel pressure tester ? I looked around and finally ended up buying a tester it was $40. but worth it. It has a bleed off button with a tube that can lead to abucket or pan to prevent fuel from getting all over the manifold.
|
|
#4
10-21-2007, 11:26 AM
|
|||
|
|||
|
Re: Thread size in Shredder valve
Thanks.
I found the thread size of the Schrader valve in the fuel rail. It's the same as the outer thread in tires: 0.305 in x 32 tpi (it's not metric no standard). I was intended to make a fuel pressure tester and found an adaptor converting Schrader to a standard thread from tire department in Meijer (had no chance in WalMart). With this adaptor, I was able to measure fuel pressure with custom made tester.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
