-
Go Back   Automotive Forums Car Chat > Honda > How-To's and Walk-Through's
Register FAQ Community
How-To's and Walk-Through's Here's where we show you how it's done!
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 08-30-2007, 07:20 AM
bronxbomber0215 bronxbomber0215 is offline
AF Newbie
 
Join Date: Aug 2007
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
91 civic radiator/headers.........

i have just orderd an after market radiator with headers .........i installed the headers but the the down pipe sounds like its ratling(only when on 1500 rpms)..... not sure of what to do with that..................the radiator i got doesn't allow the hoses to go on compltely........and will not allow the hood to close if any 1 can help plz do ...thanx
Reply With Quote
  #2  
Old 08-30-2007, 07:23 AM
orb666 orb666 is offline
AF Newbie
 
Join Date: Aug 2007
Posts: 7
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 91 civic radiator/headers.........

buy original parts from honda dealers. most of the local parts may cause overheating and will result to engine overhauling, and it may cause incompatibility with the cooling hoses esp.the upper and lower hose connected to the assembly. and pls check the operation of your thermostat and thermoswitch to avoid overheating.
Reply With Quote
  #3  
Old 08-30-2007, 08:13 AM
Greenblurr93's Avatar
Greenblurr93 Greenblurr93 is offline
Kind of a Big Deal
 
Join Date: Jun 2004
Posts: 3,900
Thanks: 12
Thanked 34 Times in 24 Posts
Send a message via MSN to Greenblurr93
Re: 91 civic radiator/headers.........

he never said it was overheating... and i usually never buy direct from Honda, most aftermarket parts are fine, just stay away from ebay.

As forthe OP's actual question.. the rattleing is most likely a heat sheild, jack up the car and check for loose heat shields.. they usually rust around where they bolt up which causes them to rest on the exhaust pipe, therefor rattleing at certain RPMs. and as for the radiator not fitting.. what brand is it? has your core support ever been bent? if worse come to worse, try bending the bottom tabs down a little and that should give you an inch or two. if you need more and dont want to buy a radiator that fits, cut the tabs and re weld them lower on the core support
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Honda > How-To's and Walk-Through's


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 12:41 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts