|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
07-10-2007, 11:48 PM
|
|||
|
|||
ignition fuse on 92 Metro
My ignition fuse on my metro keeps blowing. It will only blow when I hit the gas after stopping. Also,the car has to be warmed up. I replaced the O2 sensor, but it still happens. If I let the engine cool for about 5-10 mins then I can put in a new fuse and it'll run for a while until I getted stopped at a light. Any thoughts? 
|
|
#2
07-11-2007, 10:11 AM
|
|||
|
|||
|
Re: ignition fuse on 92 Metro
Are you using a 20 Amp fuse in the underdash fuse box for the Ignition fuse? If so, are there any other accessory's such as aftermarket car stereo's etc wired into this circut?
|
|
#3
07-11-2007, 02:39 PM
|
|||
|
|||
|
Re: ignition fuse on 92 Metro
yes it is a 20a
There was a random wire on the fuse (obviously not stock) but I have since taken it off. I have found that the problem really only shows up if the veh is warmed up and it is idleing.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
