|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
1996 silverado vortec running rough
have a 96 350 vortec hesitating to take off from dead stop. I changed fuel filter, spark plugs, dist. cap and rotor, o2 sensor, plug wires, and intake gasket. What next?
|
|
#2
|
|||
|
|||
|
Re: 1996 silverado vortec running rough
Need to check fuel pressure:
Pressure with ignition on, engine off (with engine cold and with engine warm). Pressure while starting Pressure at idle Pressure at 2000 RPMS Watch pressure after shutting engine off. Pressure will drop but should not drop way off. Post results when you have them. //2000CAYukon |
|
#3
|
|||
|
|||
|
Re: 1996 silverado vortec running rough
is there supposed to be a vacuum line hooked up to the fuel pressure regulator? dont have access to a pressure gauge. there was no vacuum hose hooked up to the regulator when i took the old one off and im not sure if there was supposed to be one
Last edited by joker1s; 06-15-2007 at 06:21 PM. |
|
#4
|
|||
|
|||
|
Re: 1996 silverado vortec running rough
No vacuum hose, doesn't need one because its inside the intake
|
|
#5
|
|||
|
|||
|
Re: 1996 silverado vortec running rough
do a compression test (cyl 3/5) plug cat from leaking injectors
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|