|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Suspension and Drivetrain Discuss suspension, and drivetrain performance modifications here. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#2
04-22-2007, 07:48 PM
|
||||
|
||||
|
Re: instruction changing rear caliper
It isn't too bad with the right tools.
1. Jack car up. 2. Remove wheel. 3. Remove the brake line into the caliper. 4. Loosen/remove the two bolts holding the caliper to the bracket. 5. Put new pads in new caliper. 6. Reverse order the steps...put the caliper on, tighten bolts, put the brake line back on, etc... 7. Bleed brakes. 8. Enjoy.
__________________
1999 Pontiac Trans Am WS.6 #1747 Stock'ish' 
|
|
#3
06-26-2007, 04:14 PM
|
||||
|
||||
|
Re: instruction changing rear caliper
yuri, mr.luos forgot one detail.......... you need to push back the hydraulic cylinders, usually theres two. if you dont push'em back, theres no way the caliper asembly will fit around the disc. and you dont need to remove brake lines, other than that you are set to go, it should take you 45 to an hour with the right tools.
__________________
 Is.... peanut butter jelly time, peanut butter jelly time, peanut butter jelly time, peanut butter jelly time.  
|
|
#4
06-26-2007, 04:23 PM
|
||||
|
||||
|
Re: instruction changing rear caliper
I'd certainly hope the job has gotten done in the past 2 months
 good catch tho, but on rears, they are twisted back in as they are threaded (most applications) 
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
