|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Classifieds This is the place to buy and sell your Honda parts. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
03-01-2007, 10:41 PM
|
|||
|
|||
|
fully built ls vtec
I am selling a b18b with AEBS sleeves overbored to 84mm with O ring, Forged Ross pistons with racing rings 9.1cr, Pauter rods, OEM ITR bearings, ITR oil pump/water pump, Greddy timing belt, Moroso autox oil pan, micropolished LS crank. Arp head studs
b16A head, buddy club SS valves, Ti retainers, Dual valve springs, spec 5 or 3 cams, cam gears, cometic head gasket, stock valve cover. engine has 0 miles, never been started or cranked. I ran out of $ to finish my proj so it never went into my car. It was built by a reputable mechanic with many years of building honda race motors. Sleeve work and bore and hone was done by aebs. I only used chose new quality parts. This engine can handle over 1000hp. asking $5000. I spent way more building it. Last edited by aznbmxxxer; 03-29-2007 at 01:59 AM. 
|
|
#2
03-06-2007, 01:03 PM
|
||||
|
||||
|
Re: fully built ls vtec
nice setup, but selling something like that engine on this site just isn't going to happen....try Honda-tech
__________________
2015 DGM STi - 2006 SGM STi - 1999 Built/boosted GSR
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
