 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
10-04-2002, 04:28 PM
|
#1 | |
|
AF Newbie
Join Date: Oct 2002
Location: Rapid City, South Dakota
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
|
Anyone know how to program keyless entry for 2001 Bonneville SSEI?
Would appreciate if anyone knows how to program a remote for a 2001 Pontiac Bonneville SSEI.
Thanks in advance, Jim |
|
|
|
|
12-17-2002, 04:18 PM
|
#2 | |
|
Blah blah blah
 Join Date: Aug 2002
Location: Auburn
Posts: 15,483
Thanks: 3
Thanked 3 Times in 3 Posts
|
I think you will have to take it to a dealer. A scan tool has to be used to program the transmitters which I think is stupid. But anyway here are the directions direct from our manual. Good Luck
Transmitter Programming Important All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter. Up to four transmitters may be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. The order in which the transmitters are programmed is important. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. The number on the transmitters are for reference only: #2 can be programmed as #1, or vice versa. Additional unnumbered transmitters are also available. Use care to program the transmitters correctly. Install a scan tool. Turn ON the ignition, with the engine OFF. Use the scan tool Remote Function Actuation Special Function: Program Key Fobs in order to place the remote control door lock receiver into Program Mode. The doors will lock and then unlock in order to confirm program mode. Important The scan tool must stay connected until all of the transmitters are programmed. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 15 seconds, the doors will lock and unlock in order to confirm the programming of that transmitter. Repeat the previous step in order to program up to 4 transmitters. Remove the scan tool. Operate the transmitter functions in order to verify correct system operation |
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
