MY engine

[1986Z28]

well its back from the machine shop, 97 vortec roller block, roller cam, aluminum heads, punched it 0.030 over , speed pro forged aluminum pistons, PM rods with arp bolts and a whole lot of other parts!

[hotrod_chevyz]

Looks sweet, other than the timing chain.

[stieh2000]

So, what size engine is this, how much Hp do you plan on making, and what is it going into?

[instantkevin]

Originally Posted by hotrod_chevyz

Looks sweet, other than the timing chain.

that is a pretty skimpy looking chain. a dual roller really doesnt cost much. it sounds like you making a good amount of torque. you might consider an upgrade (easier done now than later).

looking good! what do you have planned?
keep us updated.

[1986Z28]

i need a special chain since im running an OE roller cam, different than the regular flat tappet timing chain, that thing i have is a MASSIVE single roller which gm used and is suppose to be very strong, as most of the ndouble roller for a OE roller cam block are quite expensive and this was free(still brand new) btw its going into my 86 camaro

[1986Z28]

its a 350 bored over to 355, i wanna see roughly 450hp at the crank

[poormillionaire2]

Why not stroke it as well? 383 is a nice number.

[1986Z28]

$$$$$$

[Genopsyde]

looks good, are you gonna have it balanced as well?

[1986Z28]

already been balanced you can see the holes the welded up in the crank, cost me $200 fricken bucks too

[1986Z28]

BTW wanna race when im done

[Earlsfat]

You Canadians... Take the plastic off the engine next time you post pics, Babs. That thing might as well have been a freaking Twinky from what I could see of it.

[1986Z28]

^^^somebodys hungry, ive got pics of partial assemnly but my dam computer wont read my dam camera

[Savage Messiah]

nice, the look of an engine wrapped in plastic from the machien shop is strangely familiar to me lately

[Genopsyde]

Originally Posted by blownalcoholboy

BTW wanna race when im done

sure, if you think you can handle it.