|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
01-20-2007, 10:01 PM
|
||||
|
||||
|
Klo3 :'(
i have just finshed the KLO3 motor swap. (my O3 is a lot stronger then a ZE after i remaned it with ZE cams intake, bore ect puts out about 214hp at the crank)
i replaced the ECU in my MX with the one from my probe. but the car is not runing. are the 2 wiring harnes diffrent? i mean the one from my MX and the one From my PGT. do the points from my wiring harness run to the same sensors as the one from my PGT?? 
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
